The damage 58 mph wind leaves is a bond failure, not a hole.
For homeowners whose roof was hit by this storm and who want it measured and priced for replacement.
What a contractor finds on a wind-hit slope
Someone on the roof lifts tabs by hand along the ridge and the rakes. A tab that is still sealed resists and tears; a tab whose bond has gone comes up cleanly, and the crease from where it folded is visible along the fold line.
They also read the fasteners and the underlayment at the edges, because a course that has lifted and set back down will have moved on its nails and may have pulled the felt with it.
How this works
- You callOne number. Say you are in Rhode Island and that 58 mph wind was recorded on September 25, 2026; the call routes to a roofing contractor covering your area.
- A contractor comes outSomeone gets on the roof and looks at what 58 mph wind actually did - which slopes are affected, and how far the damage runs across each one.
- You get the scope in writingYou get a written scope: the affected slopes, the damage spread, dated photographs and a measured diagram - the record the price is built from.
The address and the roof's age are all you need to make the call.
Why one quote comes in thousands under the other
The number at the bottom of a quote is not an opinion about your roof. It is a calculation: so many squares of shingle, so much tear-off, this much metal at the edges, this many hours on site. Change what is on that list and the number moves by thousands without anybody disagreeing about rates.
What changes the list is where the contractor stood. Someone who worked along the ridge and the rakes knows how far the broken seal actually runs; someone who stayed on the ground is pricing what could be seen from it. That measured run is the area, and the area is what a slope replacement is priced on.
What a replacement actually involves
A replacement is measured on the roof and priced in writing. One call starts that.
Questions homeowners ask first
How does anyone tell a wind-damaged shingle from an old one?
By hand, on the roof. A sealed tab resists being lifted; one whose bond has released comes up cleanly and shows a crease along the fold. Age softens a shingle evenly - wind leaves a line.
What does a roofing contractor document when assessing storm damage on a roof in Block Island?
A roofing contractor typically measures wind-related damage by noting the condition of shingles, particularly at the edges, corners, and ridges where wind pressure is highest. They also document the extent of any bond weakness in the shingle sealant, which can start to occur at wind speeds around 45 mph.
When is a roof slope replaced instead of patched following wind damage?
A roof slope is generally replaced instead of patched when the damage is extensive enough that patching would not effectively restore the roof's integrity. This often pertains to areas where the wind pressure has caused significant deterioration, especially in zones experiencing sustained gusts above 58 mph.
58 mph was recorded over Rhode Island
Measured on September 25, 2026 near Block Island, Rhode Island. A broken seal does not re-bond on its own, so the next storm lifts the same tabs further than this one did. One call is enough to find out whether your slopes need replacing, and what a contractor would put in writing.